Music, my hobby

Sound recipes

Music is my hobby. These are recipes for one small rig, an OXI One MK2 sequencer, a Vermona PERfourMER MKII synth, an Electro-Harmonix Grand Canyon delay and a Strymon NightSky reverb, with every knob drawn where it should point.

Recipes

The rig, wired once

Every recipe uses the same cables, so you wire it once and only turn knobs after that.

  • OXI One MIDI out→ PERfourMER MIDI INThe OXI plays the synth. Set each OXI sequencer's output port to ALL (or the TRS port your cable uses).
  • PERfourMER main OUTPUT L→ Grand Canyon INPUTEverything panned to the centre or left goes through the effects.
  • Grand Canyon L OUT and R OUT→ NightSky LEFT IN and RIGHT INStereo from the delay into the reverb.
  • NightSky rear switchINSTLINEThe manual says to use LINE with synthesizers: it adds 10 dB of clean headroom.
  • NightSky LEFT and RIGHT OUT→ your mixer or interfaceThe wet side of the rig.
  • PERfourMER channel 2 OUT→ your mixer, dryThe bass. Its own output skips the pedals.
  • PERfourMER channel 2 PANmaxFully right, so the bass stays out of the main left output that feeds the pedals. PAN doesn't affect a channel's own output, so the dry bass is untouched. Check once: with only channel 2 playing, the pedals should be silent.

How to read a recipe

  • A knob drawing shows where to point the knob, as on a clock: 7 o'clock is fully left, noon is the middle, 5 o'clock is fully right. The blue arc is how far you've turned it.
  • A row of words is a button or switch: the dark one is the setting.
  • Each setting has one line of why under it. Read it once; after that, the drawings are enough.
  • The positions are my starting points: tune them by ear. What each control does is checked against the manual, linked at the bottom of every recipe.

Set up the PERfourMER's MIDI channels (once)

  1. Press MIDI CH.
  2. Turn SELECT/SEQ to channel 1, then press the TRIG button of synth channel 1 (and of channels 3 and 4 when a recipe asks for them).
  3. Turn SELECT/SEQ to channel 2, then press the TRIG button of synth channel 2.
  4. Press MIDI CH again to leave.

On the OXI One: hold Shift and tap sequencer 1. On page 1 of its setup, set Ch to 1. Do the same for sequencer 2 with Ch 2. To pick a sequencer's mode (Mono, Poly…), turn knob 4 on that page and press it to confirm.

Sources